●潤滑Lubrication

◆軸承潤滑Bearing lubrication

▲脂潤滑Grease lubrication

渣漿泵所用軸承在泵生產廠家已經按規定上了潤滑脂，所以在低轉速，低溫（相對于120℃）的工作條件下，本泵在使用過程中無需上潤滑脂。在高負荷高溫（相對于120℃）工作條件下的泵，軸承必須定期上潤滑脂，挖泥泵，以保證其使用壽命。對必須定期上潤滑脂的泵，必須選用和軸承原用潤滑脂相容的品種，否則潤滑效果差，影響軸承壽命。加注工具：標準手工加注槍。加注周期及加注量：對晝夜使用的泵，每周加注一次，每次每個軸承注五槍，對一晝夜工作8小時的泵，每三周加注一次，每次每個軸承注五槍，對晝夜使用的泵，也可以每月加注一次，每次每個軸承注二十槍。

The pump bearings on the grease pump manufacturers have been required at low speed, low temperature(relative to the operating conditions of 120℃), the pump during use without the need on the grease. The high temperature in the high load (relative to the pump operating conditions of 120℃), the bearings must be regularly on the grease to ensure that its service life. Grease pump must be on a regular basis, must be selected and bearing the original varieties compatible with grease or lubrication affect the bearing life. Filling tool: standard manual filling gun. Filling cycle and raise the amount of day and night use of the pump a week filling time, five shots each each bearing Note, the pump on a work night and day 8 hours every three weeks filling time, every time each bearing note five shots on the day and night to use the pump, can also be a monthly filling time, each bearing Note 20 gun.

▲潤滑油：每天檢查一次，必要時按要求加注潤滑油。

Oil lubrication: check once every day and pour lubricating oil according to requirement when necessary.